Below you will find instructions for cleaning the fill solenoid on the Profitec Pro 700. This can be helpful if your machine is not filling on startup and the pump is running incessantly.
- 2.5mm Allen Wrench
- 3mm Allen Wrench
- 14mm Crescent Wrench
1. Remove the panels from the machine: Pro 700 Panel Removal
2. Remove the nut on the outside of the solenoid with the 14mm crescent wrench.
3. Remove the solenoid shaft with the 14mm wrench.
4. Ensure there is no scale buildup or debris blocking the hole in the center or obstructing the green rubber seat.